Description
SPECIFICATION:
Size- Length - 90.97mm Width - 46.45mm High - 181.70mm
1) Battery Capacity : 4000 mAh high magnification
2) Battery Material : Upper part is a polymer plastic shell; lower part is zinc alloy
3) Atomizer Resistance : 0.5ohm
4) Two Types of Atomizers : One for concentrates, one for flower
5) Charging Current : 5V2A
6) Charging Method : Type-C
7) Weight: 500g
BEFORE USING:
1) Fill with Water - Open the lid on the small glass tube and fill with pure water, into the mouth of the suction nozzle and the small glass tube. Clean excess water before closing the lid.
2) Assembly : Insert the glass assembly into the position shown on the main unit, select the desired atomizer and screw it onto the main unit.
3) Add Concentrate or Flower : Open the atomizer cover, put in contents and then close the atomizer cover
INSTRUCTIONS :
1) Quickly press button 5 times to turn on, the current battery level will be displayed (red light below 25%, yellow light 25%-50%, blue light 50%-75%, green light 75%-100%)
2) Press the button shortly once to select the desired temperature. If no option is selected, the default is 450 degrees. LED displays the corresponding temp range ( red 450 degrees, yellow 500 degrees, blue 550 degrees, green 600 degrees)
3) Press the button shortly twice to select the required heat preservation time, if not selected the default is 20 seconds. LED displays corresponding heat preservation time (red 20 seconds, yellow 40s, blue 60 seconds, green 80 seconds)
4) Press button shortly 3 times to select prompt mode. If there is no choice selected the default is the sound prompt. There are two choices : prompt sound, prompt sound & vibration.
5) Press the button for 3 seconds to start pre heat mode, you will see the LED flash, when the heat reaches the selected temperature the LED display will stay on, a prompt noise or vibration will go off, and then its ready to use.
6) When the device is preheating, you can press the button 3 times to cancel.
7) Cleaning : Under the standby mode, press and hold the button for 6 seconds, the device will start high temp cleaning (750 degrees), when finished, it will prompt completion.
8) If the device is unused. for 5 minutes under standby mode the device will turn off.